[Miyakawa Rubber] [Made in Japan] MIYA-"Asuka" Electric Handgun Compact Electric Gun (2-Pack) with Push-in Rubber

The long-hanging double-hold specification, which features increased airtightness and two rail-like protrusions, increases initial velocity, distance, and accuracy.
It adopts a new design called "90V type long hook" with a 90° notch in the ammunition feed section of the two rails.
Nitrile and silicone hardness 50 is used to match the power of electric handheld and compact electric guns.
The hop-up adjustment lever for electric hand-held and compact electric guns has a two-point push-button design, so if you install it as is, the two rails of the packing will not come down properly.
Therefore, we developed a special push rubber to match the shape of the HOP adjustment lever.

▪️All products are made in Japan. Consistently high quality
▪️ Silicone hardness 50 / Nitrile hardness 50 (2 packs, 1 of each)

■Request■
After installing the product, please use it in accordance with the law.

■Notes■
Things to keep in mind when incorporating parallel

Miyagawa Rubber's chamber packing has an outer diameter 0.1 mm thicker than the original to improve airtightness. This can make it difficult to install into the barrel.

Do not use petroleum-based lubricants such as Kre556 . Instead, use a small amount of diluted neutral detergent.
- In the case of nitrile rubber, silicone oil can also be used.
- Silicone gaskets are not recommended as they will expand even with silicone oil.
- Fluorine oil can be used with all rubber types.

※please note※
If you have customized your airsoft gun or replaced parts, be sure to measure the bullet speed using a bullet speed meter to ensure it is within the legal limit (possession of bullets over 0.98 J is prohibited). Also, be careful not to exceed the legal limit during the work.