[GAW] Piston/Spring Guide Common Spring Spacer for Electric Guns

Pistons for electric guns with an inner diameter of 15mm or more, and an outer diameter of 10.5mm or less
This is a spring spacer that is compatible with both spring guides for electric guns.

Each sheet is 2mm thick and weighs 0.24g.
By increasing the spring, it is possible to fine-tune the initial velocity.
There are 10 sheets in one package.

Please refer to the images below for installation instructions.

When attaching to a spring guide, some models may have an R at the base.
It is important that the spring spacer does not interfere with the base R, as this may cause damage.

When you look closely, you can see that the spring spacer is resting on the base R, creating a slight gap.
If you compress the spring in this state and apply a large load, it may break at the base R part.

The solution is to increase the chamfering of the part that interferes with the root R.
This will prevent interference and allow the surfaces to touch each other.

When attaching the shaft to a tapered spring guide,
The more you stack them, the bigger the gap becomes.
Be careful not to let the spring come off the spring spacer or interfere with the piston.

When multiple spring spacers are attached to the spring guide side,
Be careful not to let the spring spacer or spring interfere with the retracting piston.
When the piston retracts again, the end face of the spring must not enter the piston.
The key is to hold on.