[Miyakawa Rubber] [Made in Japan] MIYA-"Majin" Collaboration Gasket for Electric Guns / Chamber Gasket for Marui Electric Guns (Pack of 2)

Miyagawa Rubber x Majin jointly developed "Majin Electric Packing" basic structure

▪️Protrusion structure with no stumbling hops. Stumbling hops occur when the projectile's firing position is far from the protrusion, resulting in an unstable hop.
This packing has a protrusion positioned closer to the nozzle, stabilizing the holding position and successfully reducing the occurrence of stumbling hops to as close to zero as possible.
Also, since the hop protrusion is exposed when set at zero hop, there is no deformation caused by the hop retainer, and no bullet polo.

▪️Note: A normal nozzle is recommended.
Since the protrusion is located on the nozzle side, it may not be compatible with some custom nozzles. Also, the amount of protrusion varies depending on the inner diameter of the barrel, so you may need to adjust it with a push-in rubber.

・All products are made in Japan. Consistently high quality.

■Request■
After installing the product, please use it in accordance with the law.

■Notes■
Things to keep in mind when incorporating parallel

Miyagawa Rubber's chamber packing has an outer diameter 0.1 mm thicker than the original to improve airtightness. This can make it difficult to install into the barrel.

Do not use petroleum-based lubricants such as Kre556 . Instead, use a small amount of diluted neutral detergent.
- In the case of nitrile rubber, silicone oil can also be used.
- Silicone gaskets are not recommended as they will expand even with silicone oil.
- Fluorine oil can be used with all rubber types.

※please note※
If you have customized your airsoft gun or replaced parts, be sure to measure the bullet speed using a bullet speed meter to ensure it is within the legal limit (possession of bullets over 0.98 J is prohibited). Also, be careful not to exceed the legal limit during the work.