[Jefftron] Mosfet II with wiring

A general-purpose 6-wire FET switch.
It's a simple FET switch with no programmability whatsoever.

The FET used is Infineon IPT004N03L , which is a significant improvement over the previous version.

The unit itself measures 25mm x 12mm x 7mm.
(shrink tubing and wiring not included)

This package includes wiring.
The wiring on the motor and battery sides is Alpha Wire Eco Wire 16AWG (outer diameter Φ2.1mm),
Each one is 500mm long.

Also included: 1 male T-type connector, 1 30A mini fuse, 4 Faston terminals, and a set of shrink tubing.

It is a set.

Manufacturer recommended operating conditions Battery voltage: 17V or less Spring guide: M210 or less Load in semi-auto mode: 150A or less Load in full-auto mode: 50A for 30 seconds or less

*Note*
Soldering skills are required for installation. Be sure to use a fuse.

Damage to the product itself caused by incorrect wiring or soldering will not be covered by the warranty.
In addition, installing these parts may void the manufacturer's warranty on the gun itself.