WE-Tech Japan-specification injection valve compatible with all gas blowback magazines
In the case of gas guns made overseas, if the magazine has an injection valve designed for overseas high-pressure gas, it can be difficult to inject with Japanese refrigerant gas because there is no injection sound and no blowback.
By simply replacing it with this valve, you will be able to inject gas in the same way as with domestically produced gas guns.
*If you are using it in a handgun magazine, you will need to slightly sand down the edge on the injection port side.
*If the O-ring protrudes when tightening, reuse the O-ring from the valve before replacement.
*If you apply a light amount of silicone oil before replacing the O-ring, it will fit smoothly without damaging it.
![[WE] Japan-specification injection valve for rifle/handgun gas magazines](http://rock-et.jp/cdn/shop/products/4580492873772_1024x1024.jpg?v=1636027624)
![[WE] Japan-specification injection valve for rifle/handgun gas magazines](http://rock-et.jp/cdn/shop/products/4580492873772_1_1024x1024.jpg?v=1636027624)
![[WE] Japan-specification injection valve for rifle/handgun gas magazines](http://rock-et.jp/cdn/shop/products/4580492873772_2_1024x1024.jpg?v=1636027625)
![[WE] Japan-specification injection valve for rifle/handgun gas magazines](http://rock-et.jp/cdn/shop/products/4580492873772_medium.jpg?v=1636027624)
![[WE] Japan-specification injection valve for rifle/handgun gas magazines](http://rock-et.jp/cdn/shop/products/4580492873772_1_medium.jpg?v=1636027624)
![[WE] Japan-specification injection valve for rifle/handgun gas magazines](http://rock-et.jp/cdn/shop/products/4580492873772_2_medium.jpg?v=1636027625)
