[PDI] 1st Sear / for Tokyo Marui VSR-10

Made from S45C for unparalleled strength.
Despite being a stress-bearing part, the original sear is made of zinc die-cast, which leaves considerable uncertainty about its strength. Repeated use can cause wear, which can lead to imbalance of the sear and ultimately lead to failures other than the trigger system. The PDI 1st sear is made of high-strength S45C steel, which is machined with high precision using a wire EDM. This overcomes any durability issues.

*Cannot be used with PDI Nutriger.

Specifications
■Compatible models:
#Compatible with Tokyo Marui VSR-10 series
■Material: Carbon steel
■Surface treatment: Black dyeing

Instructions are here (will take you to the manufacturer's website and open in a new tab)


※please note※
If you have customized your airsoft gun or replaced parts, be sure to measure the bullet speed using a bullet speed meter to ensure it is within the legal limit (possession of bullets over 0.98 J is prohibited). Also, be careful not to exceed the legal limit during the work.