No Products in the Cart
E-Shooter Kestrel V2 Basic Electronic Trigger!
This is the latest electronic trigger unit from Eshooter, a company that has been releasing a series of high-performance electronic devices for airsoft guns, with reduced functionality and a lower price than the high-performance Kestrel V2 electronic trigger series.
It uses the latest layout that is compatible with airsoft gun tuning.
Although the cut-off switch is mechanical, it is cleverly positioned to allow detection and pre-cocking settings that are compatible with high-cycle and DSG engines.
The pre-cocking level can be set to 6 levels, including 5 levels of release, and it has a unique learning function that automatically adjusts the pre-cocking position according to speed and load.
It can be set to semi-auto, binary trigger (pull the trigger, release it to fire one shot, then fire one shot), or full auto with 3-round burst.
It is equipped with the automatic active brake that is also featured in the high-performance Kestrel V2, and natively supports brushless motors, so it can also be further customized and tuned up.
*Micro trigger switch
The trigger switch is mechanical and responds to minute strokes, so it can also be tuned to work as a hair trigger.
★Highly efficient wiring
High-efficiency wiring and T-plug connectors are standard equipment for wiring, improving power transmission efficiency.
★Safety equipment
If the device is left idle for approximately an hour, it will enter sleep mode to prevent over-discharge of the battery and will resume operation when the connector is reconnected.
When the battery level is low, the motor will vibrate (it will vibrate for 2 seconds if the battery is less than 6V, and 5 times every 3 seconds if the battery is less than 8.5V).
★Self-test function
Each switch is equipped with an LED that indicates its status, which is useful for troubleshooting.
★Compatible models
Since it was developed based on the standard electric gun Ver. 2 gearbox, it is compatible with Ver. 2 gearboxes sold by Tokyo Marui and other domestic and overseas companies (processing may be required).
Simply installing the Kestrel V2 will significantly improve the performance of your electric gun, giving you a definite advantage in airsoft games.
-Kestrel V2 Basic Feature Overview-
・5-stage adjustable pre-cocking
- Automatic pre-cocking correction
・Active braking
- Sleep mode
- Low voltage warning function
Battery protection
・Cycle detection
・Sensor calibration
・MOSFET
- Brushless motor compatible
- T plug connector specifications
-Kestrel V2 Specifications-
・Compatible voltage range: 3.75-17V
・Current consumption: 20mA
・Size: 47.4 x 28.7 x 1 mm
Operating temperature: -15 to 100°C
・Humidity: ?80%
★Product contents
Eshooter Kestrel V2 BASIC main unit 1
Shim washer
Lock washer
bis
Heat shrink tubing
T plug connector (female)
Spare sticker
Installation instructions (English)
Eshooter official website: https://eshooter-world.com/
*Installation requires disassembly of the electric gun.
*The warranty does not cover damage caused by incorrect installation, water damage, reverse connection, short circuit, or modifications made by the customer.
*Please note that due to the design of the electronic board, it is assumed that a Li-Po battery will be used, and therefore nickel-metal hydride batteries are not supported.
*Please remove the battery when not in use. Leaving it connected will continue to energize the electronic board, which may result in malfunction.
*Please be sure to read the Eshooter homepage carefully before using.
