Equipped with only the motor brake function
A 6-wire general-purpose FET switch.
After launch, the motor is stopped suddenly by short braking.
A gun with a cycle so fast that it would burst a semi-automatic weapon.
This is an effective product when you want to stop the piston precisely.
Unlike electronic triggers, the motor brake cannot be set in stages.
It is always at maximum braking.
This causes the motor commutator and brushes to wear out quickly.
The unit itself measures 27mm x 10mm x 7mm.
This is a kit without wiring.
You will need to prepare and solder the power and signal lines separately.
Manufacturer recommended usage conditions
Battery voltage: 17V or less
Spring guide: M160 or less
Load in semi-automatic mode: 75A or less
Load in full auto mode: 25A for 30 seconds or less
*Note*
Soldering skills are required for installation. Be sure to use a fuse.
Damage to the product itself caused by incorrect wiring or soldering will not be covered by the warranty.
In addition, installing these parts may void the manufacturer's warranty on the gun itself.
This product is not compatible with brushless motors for electric guns.
Never use together.
![[Jefftron] Micro active brake II](http://rock-et.jp/cdn/shop/files/JT-BRK-S1_1024x1024.webp?v=1753333769)
![[Jefftron] Micro active brake II](http://rock-et.jp/cdn/shop/files/JT-BRK-S1_2_1024x1024.png?v=1753333769)
![[Jefftron] Micro active brake II](http://rock-et.jp/cdn/shop/files/JT-BRK-S1_1_1024x1024.webp?v=1753333769)
![[Jefftron] Micro active brake II](http://rock-et.jp/cdn/shop/files/JT-BRK-S1_medium.webp?v=1753333769)
![[Jefftron] Micro active brake II](http://rock-et.jp/cdn/shop/files/JT-BRK-S1_2_medium.png?v=1753333769)
![[Jefftron] Micro active brake II](http://rock-et.jp/cdn/shop/files/JT-BRK-S1_1_medium.webp?v=1753333769)
