This external carbon dioxide (CO2) power system has a lower environmental impact than standard refrigerant gas. Its pressure changes little with temperature, maintaining stable power even in low-temperature environments or when the temperature drops due to rapid fire. It's also the most compact external-source system available. Due to its characteristics, it's a popular system in the speed shooting world, and with the increase in tatami room shooters due to the stay-at-home lifestyle, it's now experiencing a quiet boom.
Variable regulator for Sun Project Green Gas System.
This is a regulator (pressure adjuster) designed specifically for use with 74g Green Gas cylinders.
The discharge pressure can be adjusted from 0 to the maximum set pressure using the open/close knob on the top of the regulator. You can make fine adjustments while watching the pressure meter.
The regulator is equipped with a 6mm hose joint, allowing connection of a compatible pressure-resistant urethane hose or coil hose (hose sold separately).
Size: W48mm x D70mm x H86mm (including accessories) Weight: 400g
Maximum discharge pressure: 0.5MPa (±0.05MPa)
Discharge pressure meter, 6mm hose joint, belt clip
*Please attach the belt clip yourself. A Phillips head screwdriver is required.
■About the Green Gas System●The Green Gas System is a product that supplies stable pressure from the outside to recreational gas guns.
●Unlike refrigerant gas, there is no pressure drop due to drops in temperature in winter, and the pressure drop due to a drop in gas temperature that occurs during continuous firing is significantly less, so it can be used at a stable gas pressure throughout the year.
●The regulator has a maximum discharge pressure setting. The pressure cannot be changed beyond the setting.
●If abnormal pressure occurs inside the regulator due to the inflow of raw gas, etc., the safety valve will activate and release the internal pressure from the safety valve.
■Precautions for use●Never use gas cylinders other than genuine green gas.
●Never modify, alter or repair the regulator yourself.
After connecting to the gun, please check the bullet speed before use. Always measure at the regulator's maximum discharge pressure.
●When using carbon dioxide gas cartridges, please handle them correctly as described in the instruction manual for the device you are using.
●Avoid direct sunlight and do not place in places where the temperature exceeds 40°C.
●Even if a small amount of gas leaks out when installing, just screw it in all the way.
●After installation, do not remove from the appliance until all the gas has been discharged.
●Please use within the temperature range of 0 to 40°C.
●If white frost forms on the surface, do not touch it directly with your bare hands. Instead, wrap gloves or a cloth around it to remove it.
●After confirming that the seal of the used cartridge is punctured, dispose of it as non-combustible waste. Also, do not throw it into a fire.
●Please store in a safe place out of reach of children.
