[ORGA] MWS/MK18/MTR/Block 1 Compatible FRA Nozzle ASSY

* If the product is out of stock, it may take 3-4 business days to 2 weeks for delivery.

FRA Nozzle Assy for MWS/MK18/MTR/Block 1

It's no exaggeration to say that this is "the first thing to get" when operating with Tokyo Marui's M4 gas blowback series! !

This is a reinforced polymer power-adjustable nozzle that can be used with Tokyo Marui's gas blowback M4 series, MWS, CQB-R Block1, MTR16, and MK18Mod1.

The FRA (Flow Rate Adjustment) nozzle allows you to adjust the gas flow rate inside the loading nozzle by inserting a wrench from the tip of the nozzle and turning it.

This allows you to adjust the gas blowback's muzzle velocity and blowback performance according to the season and weather, which are affected by temperature, such as with HFC134a and HFC152a, and also allows for power adjustment when using high-pressure gas.

Because it uses reinforced polymer, it is stronger than Tokyo Marui's genuine nozzle and is an effective part to avoid the risk of damage.

Insert the included adjustment wrench from the tip of the nozzle into the flow valve. Turning it counter-clockwise will distribute gas flow to the nozzle side (increasing muzzle velocity), and turning it clockwise will distribute gas flow to the blowback side (decreasing muzzle velocity). For flow rate adjustment, it is recommended to turn the wrench about 1/4 of a turn at a time and measure the bullet velocity.

Although this part is basically for adjusting to lower the muzzle velocity and improve blowback comfort, if the nozzle side is set to MAX, the muzzle velocity will be slightly higher compared to the genuine product.

*Please note that if you over-tighten the adjustment screw, the screw inside may come loose and adjustment will no longer be possible.
*Please note that scratches or lines may appear on the surface of the nozzle during manufacturing, but this does not affect its strength or durability.
*The firing pin stopper may be difficult to install. In that case, please shave off the surface of the stopper with a file or similar tool to make it fit.