[Kuramae Studio] APS-3 17-Round Magazine

This is a new 17-round magazine for APS-3.

The lower section uses a genuine magazine to ensure reliability, while the upper section is made with a 3D printer, significantly reducing manufacturing man-hours and enabling cost reduction.

Unlike conventional models, it is now possible to load BBs from a BB bottle while holding the grip.
*The magazine can hold 17 BBs. If BBs are loaded while the magazine is attached to the gun body, 18 BBs can be loaded.
*The gun body, BBs, and BB bottle are not included.

[How to use the 17-round magazine]


① Pull the follower towards you and hook it into the notch. *Note 1



② With the gun held horizontally, insert the BB bottle into the BB loading port.
　While pushing the stopper forward with the tip of the bottle, make the gun and bottle vertical.
　At this time, point the muzzle downwards.
　Confirm that BBs are loaded into both the upper and lower sections.

③ Unhook the follower from the notch and apply spring tension to the BBs, and it's ready to fire. *Note 2
④ After firing 5 or 6 shots, perform step ① and point the muzzle downwards.
⑤ Once the BBs have flowed from the upper section to the lower section, perform step ③, and repeat thereafter.

*Note 1
If you forget step ① and load, BBs will only be loaded into the upper section.
Also, if using a speedloader and you forget step ①, BBs will be pushed into the spring, rendering it unusable.
Whenever possible, please feed directly from the BB bottle without using a speedloader.

*Note 2
If you forget step ②, multiple BBs will be loaded into the chamber, causing BB drops.
If BB drops occur, it is because step ③ was forgotten, or for some reason, spring tension is not applied to the BBs.
If BB drops occur, please check if the follower is operating correctly.

Even if the APS-3 experiences BB drops, one BB will still be loaded in the chamber.
Even if BB drops occur, shooting is still possible without issues, so please be careful.