[da Vinci Custom] 08 Guren "2" CO2 Gas Blowback Compatible Inner Barrel

*Please note that this item is made to order and will take approximately 1-2 weeks to be shipped after your order is placed.

08 Guren 2 Inner Barrel (please select the type and length)
Inner diameter 6.08mm
Outer diameter 8.55mm
HV500 coated (hardened, rust-proof, wear-resistant, and slip-resistant)

For CO2-GBB/M17-LAYLAX 105mm
112.5mm for CO2-GBB/M45-Carbon 8. In terms of output, it is equivalent to the original barrel (6.03) and there is no significant reduction.

The second release in the Guren series, a low-priced inner barrel series featuring an inner diameter of 6.08mm, the same as the original, and coated with the "HV500 Coat" for excellent wear resistance, stain resistance, and maintaining a beautiful surface!
Guren "2" aims to produce a professional-use barrel using iron.
The material and coating used is the same "HV500 Coat" as the Guren 1.
The muzzle has been upgraded from the "chamfered" finish of the Guren 1 to a "tapered" finish. The "tapered" finish efficiently expels air and converts it into energy that pushes the bullet forward, while creating a straightened airflow and improving accuracy.

The 6.08mm inner barrel maximizes the powerful shot trajectory unique to CO2.
Due to the power of CO2 gas blowback, it is compatible with an inner diameter of 6.08mm.
While maintaining the same output as the original inner barrel, the wide inner diameter of 6.08mm supports the trajectory by reducing the number of bullet collisions.
*Output is greatly affected by external factors such as temperature and humidity, so it may not apply to all situations.

About Carbon8
The Carbon8 stock inner barrel has an outer diameter of approximately 8.5mm, which is smaller than the Tokyo Marui stock inner barrel. The Guren has an outer diameter of 8.55mm, so we cut out the necessary area to adjust it.

Guren's inspection standards include three internal diameter inspection points: "after polishing," "before coating," and "after coating."
In particular, we physically check to see if any burrs generated during processing have affected the inner diameter.
The polishing is then checked again by the "human eye" of a select few craftsmen in charge of polishing.
We put in time and effort to provide a thorough user experience.
Regarding roughness of the inner and outer diameters due to the material, and patterns that occur during processing (cutter marks, blade marks, etc.) that do not affect use,
After going through the above checks, the craftsman has given his permission, so please use it with confidence.