[da Vinci Custom] 03 Guren "1" Micro Mecha Box Compatible Inner Barrel

*Please note that this item is made to order and will take approximately 1-2 weeks to be shipped after your order is placed.

03 Guren 1 Inner Barrel (please select the type and length)
Inner diameter 6.03mm
Outer diameter 8.55mm
HV500 coated (hardened, rust-proof, wear-resistant, and slip-resistant)

110mm for AEP/GLOCK18C
112mm for AEP/USP
115mm for AEP/HK45
122mm for AEP/M93R
122mm for AEP/HI-CAPA E
127mm for AEP/SCORPION
135mm for AEP/MAC10
182mm for AEP/MP7
242mm for AEP/MP7 LONG

Introducing the low-priced inner barrel series, Guren! It features a tight design with an inner diameter of 6.03mm, and is coated with the "HV500 Coat" which is highly resistant to wear and dirt, while maintaining a beautiful surface!
The Guren "1" was developed with the aim of releasing a barrel at the lowest possible price.
Because we cannot compromise on materials and coatings, we limit the processing methods and areas used to achieve low costs. All muzzle ends are chamfered to ensure a barrel that does not clog. This process shortens processing time and reduces the amount of metal waste generated during processing, lowering the product's reject rate and allowing us to set lower prices.

The 6.03mm inner diameter is a tight barrel design that makes it easy to increase muzzle velocity. <br>The inner diameter is set to a tight 6.03mm, so you can expect to improve muzzle velocity just by replacing the barrel.
This product is made of iron. Unlike stainless steel, due to tolerances, the tightest design limit is an inner diameter of 6.03 mm.
If you set it any tighter, it will jam.

*Toy guns are made up of many parts. Depending on the combination of parts, performance may not be achieved.

The barrel compatible with the Micro Mecha Box basically uses a design that conforms to the original.

※please note
The following products have grooves at the tip and are special barrels, so please choose the special barrel that is right for your gun.
・HK45
・HI-CAPA E

Guren's inspection standards include three internal diameter inspection points: "after polishing," "before coating," and "after coating."
In particular, we physically check to see if any burrs generated during processing have affected the inner diameter.
The polishing is then checked again by the "human eye" of a select few craftsmen in charge of polishing.
We put in time and effort to provide a thorough user experience.
Regarding roughness of the inner and outer diameters due to the material, and patterns that occur during processing (cutter marks, blade marks, etc.) that do not affect use,
After going through the above checks, the craftsman has given his permission, so please use it with confidence.