[da Vinci Custom] Pro Sniper Barrel Spacer / VSR-10

*Please note that this item is made to order and will take approximately 1-2 weeks to be shipped after your order is placed.

POM barrel spacer designed exclusively for Pro Sniper.
Set of 2.
Made by POM, fully CNC machined.

The inner barrel is firmly fixed on the side of the nozzle and the chamber.
Reduces shaking and improves accuracy.

The material used is POM, which reduces the vibration coefficient, and two O-rings are set inside.
In addition, since the outer barrel for the Pro Sniper has a tapered section on the inside, the outside of the barrel spacer is gently tapered.
The front spacers are designed to be fixed approximately 140mm from the front, and the rear spacers are designed to be fixed approximately 290mm from the front.

*Due to the gradual tapered design, it may appear difficult to tell the front from the back at first glance.
When assembling, use the size of the "inner diameter tapered surface" as a guide to determine the front and back. The side with the larger chamfer will be the front.
If you install it the other way around, it will not fit properly into the outer barrel.

*The tolerances inside the outer barrel of the Pro Sniper appear to vary greatly depending on the lot.
If it does not fit, please take measures such as wrapping sealing tape around the outer periphery. All of the lots we have confirmed can be installed without any modifications.

Reducing the vibration of the inner barrel, which is an important part when shooting, is the key to improving accuracy.