[da Vinci Custom] 17 Guren "1" Inner Barrel for VSR-10

*Please note that this is a special order item and will take approximately one month from the time of order until shipping.

17 Guren 1 Inner Barrel (please select the type and length)
Inner diameter 6.17mm
Outer diameter 8.55mm
HV500 coated (hardened, rust-proof, wear-resistant, and slip-resistant)

303mm for VSR-10 G-SPEC
430mm for VSR-10 PRO SNIPER
500mm for L96 AWS

Introducing the Guren, a low-priced inner barrel series featuring a loose barrel with an inner diameter of 6.17mm and an HV500 coating that is highly resistant to wear and dirt while maintaining a beautiful surface!
The Guren "1" was developed with the aim of releasing a barrel at the lowest possible price.
Because we cannot compromise on materials and coatings, we limit the processing methods and areas used to achieve low costs. All muzzle ends are chamfered to ensure a barrel that does not clog. This process shortens processing time and reduces the amount of metal waste generated during processing, lowering the product's reject rate and allowing us to set lower prices.

By simply replacing the barrel, you can reduce the excessive output.
The 6.17mm inner diameter barrel can reduce output simply by installing it.
So far we have tested inner diameters of 6.10mm and 6.12mm, but contrary to our expectations, there was no impact in terms of low output.
In today's world where even lower output is required, we have established an inner diameter that can be adjusted by simply replacing the barrel without changing the barrel length or settings.

*Toy guns are made up of many parts. Depending on the combination of parts, performance may not be achieved.
Barrels for the VSR-10/L96 are available in G-SPEC size (303mm), Pro Sniper size (430mm), and L96 AWS size (500mm). They are chamfered at 45 degrees to prevent damage to the hop-up seal.

Guren's inspection standards include three internal diameter inspection points: "after polishing," "before coating," and "after coating."
In particular, we physically check to see if any burrs generated during processing have affected the inner diameter.
The polishing is then checked again by the "human eye" of a select few craftsmen in charge of polishing.
We put in time and effort to provide a thorough user experience.
Regarding roughness of the inner and outer diameters due to the material, and patterns that occur during processing (cutter marks, blade marks, etc.) that do not affect use,
After going through the above checks, the craftsman has given his permission, so please use it with confidence.