A general-purpose 6-wire FET switch.
It's a simple FET switch with no programmability whatsoever.
The FET used is
Infineon IPT004N03L , which is a significant improvement over the previous version.
The unit itself measures 25mm x 12mm x 7mm.
This is a kit without wiring, so you will need to prepare and solder the power and signal wires separately.
Manufacturer recommended operating conditions Battery voltage: 17V or less Spring guide: M210 or less Load in semi-auto mode: 150A or less Load in full-auto mode: 50A for 30 seconds or less
*Note*
Soldering skills are required for installation. Be sure to use a fuse.
Damage to the product itself caused by incorrect wiring or soldering will not be covered by the warranty.
In addition, installing these parts may void the manufacturer's warranty on the gun itself.
![[Jefftron] Mosfet II](http://rock-et.jp/cdn/shop/files/JT-MOS-S2_1024x1024.webp?v=1753332691)
![[Jefftron] Mosfet II](http://rock-et.jp/cdn/shop/files/JT-MOS-S2_1_1024x1024.webp?v=1753332700)
![[Jefftron] Mosfet II](http://rock-et.jp/cdn/shop/files/JT-MOS-S2_2_1024x1024.png?v=1753332700)
![[Jefftron] Mosfet II](http://rock-et.jp/cdn/shop/files/JT-MOS-S2_medium.webp?v=1753332691)
![[Jefftron] Mosfet II](http://rock-et.jp/cdn/shop/files/JT-MOS-S2_1_medium.webp?v=1753332700)
![[Jefftron] Mosfet II](http://rock-et.jp/cdn/shop/files/JT-MOS-S2_2_medium.png?v=1753332700)
