[Kuramae Studio] APS-3 17-Round Magazine

*As this is a 3D printed product, it may soften at high temperatures or deform due to external pressure. Avoid prolonged exposure to environments above 45 degrees Celsius or storage methods that apply continuous load. Also, please refrain from ordering during summer, as deformation due to high temperatures may occur during shipping.

This is a new 17-round magazine for the APS-3.

The lower section uses a genuine magazine to ensure reliability, while the upper section is 3D printed, significantly reducing production man-hours and enabling cost reduction.

Unlike conventional models, it is now possible to load BBs directly from a BB bottle while holding the grip.
*The magazine can hold 17 rounds. If you load BBs with the magazine attached to the gun, it can hold 18 rounds.
*Gun body, BBs, and BB bottle are not included.

【How to use the 17-round magazine】


① Pull the follower back and hook it into the notch. *Note 1



② With the gun held horizontally, insert the BB bottle into the BB loading port.
Push the stopper forward with the tip of the bottle, then hold the gun and bottle vertically.
At this time, point the muzzle downwards.
Confirm that BBs are loaded into both the upper and lower sections.

③ Release the follower from the notch to apply spring tension to the BBs, and it's ready to fire. *Note 2
④ After firing 5 or 6 shots, perform step ① and point the muzzle downwards.
⑤ Once the BBs have flowed from the upper section to the lower section, perform step ③, and repeat the process thereafter.

*Note 1
If you forget step ① and load, BBs will only be loaded into the upper section.
Also, if using a quick loader, forgetting step ① will cause BBs to be forced into the spring, rendering it unusable.
Whenever possible, load BBs directly from the BB bottle without using a quick loader.

*Note 2
Forgetting step ② will cause multiple BBs to be loaded into the chamber, resulting in BB drop-out.
If BB drop-out occurs, it is because step ③ was forgotten, or for some reason, spring tension is not being applied to the BBs by the follower spring.
If BB drop-out occurs, check if the follower is operating correctly.

Even if BB drop-out occurs with the APS-3, one BB will still be loaded into the chamber.
Even if BB drop-out occurs, shooting is still possible without problems, so please be very careful.