LAMBDA DEFENCE B&T GHM9-G Gas Blowback Pistol (Japan Model) - BLACK

*Please be sure to read the description carefully to the end, and only order if you are satisfied with the product.

Due to packaging restrictions, the cocking lever must be installed by the user.

Lambda Defense GHM9-G gas blowback gun, Japan spec!
Officially licensed by B&T for a realistic reproduction!

This is a reasonable entry model that omits sights, hiders, and stock.
You can enjoy your preferred specifications with upgrade optional parts.

【Features】

- Lightweight due to extensive use of nylon fiber in the main exterior (upper/lower receiver, etc.) - Ambidextrous selector as standard - Ambidextrous bolt catch as standard - Ambidextrous magazine catch as standard

Left- or right-handed cocking lever. Compatible with Action Army AAP01 series magazines. Picatinny stock compatible stock base. 14mm reverse thread compatible outer barrel (please install carefully as it is very tight).
(Processing may be required in some cases)

Compatible with Tokyo Marui GBB inner barrels and gaskets (some exceptions apply). Compatible with real/GBB grips (may require modification depending on grip).
・Japan-specification injection valve ・Japan-specification internal parts

【specification 】

[Contents]

・Main unit ・Magazine x1
・ Cocking handle x1
・Parts list x1

[Notes]

*There may be manufacturing scratches, surface scuffs, dents, etc.

*There are small holes and poor construction in the lower receiver on the back of the magazine catch, but there are no problems with strength and it is within the specifications.

*Although the product meets the manufacturer's strength standards, this is not guaranteed.
Sufficient break-in and environment is required for smooth operation.
It's especially difficult to move around in the winter.
Please be aware of this.

<How to install the cocking lever>

Do this with the magazine removed.

1. Use a punch and rubber hammer to strike the receiver lock (rear side) and pin stock base pin until the stock base comes off.

② Slide the stock base downward to remove it.

③Using the front takedown pin as a fulcrum, slightly lift the rear of the upper receiver.
(Image of M4/AR15)

④ Remove the recoil spring and buffer.

⑤ Insert the cocking lever into the bolt hole about 80% and pull it back.

⑥ Fully insert the receiver groove where the bolt and cocking lever intersect.

⑦ Move the cocking lever forward to its designated position.

⑧ Set the recoil spring and buffer

9. Assemble the stock base and fire a blank to complete the process.