[Kuramae Koubou] APS-3 Original Front Sights

*Since this is a 3D printed product, it may soften at high temperatures or deform due to external pressure. Avoid prolonged exposure to environments above 45 degrees Celsius or storage methods that apply continuous load. Also, please refrain from ordering in the summer as there is a possibility of deformation due to high temperatures during transportation.

We have improved visibility by incorporating a light-gathering acrylic into a front sight produced by a 3D printer.
We have also prepared sizes not available in genuine front sights and a version without light-gathering acrylic, so please refer to the product description below.
*Prices are per piece.

【Front Sight Width】
You can choose from 3 types: 4.5mm / 4.8mm / 5mm.

【Front Sight Height】
There are two types: High and Low. High is approximately 1mm taller than the normal sight.
Low is almost the same height as the genuine front sight.

【Light-gathering Acrylic Installation Shape】

You can choose from two types: conventional and horizontal.

【No Light-gathering Acrylic】
For the 5.0mm width, we have prepared two versions without light-gathering acrylic.





～How to choose various front sights～

【Front Sight Width】
If you feel that the recess of the genuine rear sight is too wide and makes sight alignment difficult to see, please select the 5mm width.

↑How the 5mm width front sight looks
*The gap between the front sight and rear sight varies greatly depending on the distance from the eye to the sight (arm length).

【Front Sight Height】
If you want to lower the point of impact, please choose High.
For competitive shooting, a 6 o'clock hold is recommended, but if the point of impact cannot be lowered enough even when adjusted to the maximum range on some individual guns, or if there are restrictions such as only being able to use light BBs at the shooting range and not being able to achieve the desired 6 o'clock hold, please choose High.

【Light-gathering Acrylic Installation Shape】
The horizontal type has the advantage of appearing perfectly round when viewed from the front, as the end face of the light-gathering acrylic is viewed directly, with the acrylic installed in the same direction as the shooter's line of sight.
Also, since there is more exposed light-gathering acrylic, it appears brighter.
The light-gathering acrylic diameter is 1.5mm, and it is fixed with a set screw.
You can also purchase a 1.5mm light-gathering acrylic rod separately for repair in case of damage.

The conventional type has a shape equivalent to that of the genuine front sight that has been sold by Kuwata Kōbōsha for some time, and the light-gathering acrylic used is the same 1.8mm diameter as the conventional one, fixed with a set screw.

*JASG certified parts.
*The horizontal type has a large exposed portion of the light-gathering acrylic, so please be careful not to damage the acrylic when attaching or detaching the muzzle cover.
*Please note that there may be some individual differences in the finish, and it may differ from the photos. Thank you for your understanding.