[PDI] Front Bull Barrel P-Flute / for PDI VSR-10 Bull Barrel Base, PDI L96 Bull Barrel Base, 350mm

Tokyo Marui VSR-10 Front Bull Barrel P (Pro Sniper Size)

Fully CNC machined from aluminum alloy.

Fat military model, "Bull Barrel" specification
This model recreates the fat barrel, which is not tapered. This barrel shape is common in military models, and emphasizes its strength. It makes the VSR-10 even more attractive.

3mm deep, fully machined "Flute Barrel"
The four sharp flutes, each 3mm deep, are made possible by a wall thickness of nearly 6mm.

"P" for Pro Sniper
For the VSR-10 P size (when used with the Bull Barrel Base), an inner barrel length of 430mm is required separately.

Equipped with an O-ring at the base
Since this is a two-piece barrel that requires a tight tightening feel, an O-ring is installed at the joint, which is extremely effective in reducing rattle and increasing rigidity.

Please purchase the spacer for the front bull barrel.
The inner diameter is tighter than the G-Spec due to the increased thickness, so a dedicated barrel spacer is required.
"Barrel spacer for front bull barrel" is compatible.
Two types of O-rings are installed inside and outside to hold the inner barrel in place and reduce vibration.
It is the perfect tool to improve shooting accuracy.

*PDI Bull Barrel Base is required for use.

Specifications
■Compatible models:
#PDI Bull Barrel Base
■Material: Aluminum alloy
■Surface treatment: Black anodized
■Size: Length 350mm (including screw)

[About anodized aluminum products]
*During the anodizing process, unevenness or marks of a few millimeters may remain where the product is fixed.
*Since the screw part is inspected after the anodizing process, some of the anodizing on the screw part may peel off, resulting in silver areas, but if there is no problem with the functionality, we will treat it as a normal product.
*We have confirmed that the product can be used without any functional impact, so we do not accept returns or exchanges for cosmetic reasons.


※please note※
If you have customized your airsoft gun or replaced parts, be sure to measure the bullet speed using a bullet speed meter to ensure it is within the legal limit (possession of bullets over 0.98 J is prohibited). Also, be careful not to exceed the legal limit during the work.