[PDI] Attachment, Right-Handed Thread M14 / Tokyo Marui GLOCK17

This product is a right-handed thread specification.
Please be careful not to make any mistakes!

This 14mm threaded attachment is compatible with the Tokyo Marui GLOCK17. It requires a "long barrel" longer than the stock inner barrel (HI-CAPA 6-inch or 7-inch sizes).

PDI attachment for easy expansion
Three set screws are placed around the perimeter of the barrel, locking it evenly to the extended barrel from all directions. This prevents the compensator, silencer, etc. from shifting due to the impact of blowback. The attachment has an inner diameter of 8.7mm, which firmly holds the inner barrel and improves accuracy.
We recommend using a PDI stainless steel inner barrel.
As it is made of stainless steel (SUS304), tightening will not affect the inner diameter. However, please be careful not to tighten it too much.

The combinations are as follows:
6-inch 01 inner barrel...protrudes approximately 13mm from the tip of the attachment
7-inch 01 inner barrel...protrudes approximately 38mm from the tip of the attachment

Specifications
■Compatible models:
#Tokyo Marui GLOCK17
■Material: Aluminum alloy
■Surface treatment: Black anodized

[About anodized aluminum products]
*During the anodizing process, unevenness or marks of a few millimeters may remain where the product is fixed.
*Since the screw part is inspected after the anodizing process, some of the anodizing on the screw part may peel off, resulting in silver areas, but if there is no problem with the functionality, we will treat it as a normal product.
*We have confirmed that the product can be used without any functional impact, so we do not accept returns or exchanges for cosmetic reasons.


※please note※
If you have customized your airsoft gun or replaced parts, be sure to measure the bullet speed using a bullet speed meter to ensure it is within the legal limit (possession of bullets over 0.98 J is prohibited). Also, be careful not to exceed the legal limit during the work.