[PDI] Nutrigger 2 End Set for Tokyo Marui VSR-10

Trouble-free! Stress-free shooting!
By changing the sear shape and angle of the hook, the heavy cocking response has been fundamentally eliminated.
The special piston end attached gives the sear a sharper "sharpness" than the stock, and the feeling of the sear "falling" is clearly apparent.
*Please use the included piston end with PDI HD pistons, VC pistons, and BaRiKaRu pistons (discontinued).

The trigger box is machined from an aluminum block. The trigger sear and trigger, which are subject to force, are cut from carbon steel.
- The trigger is equipped with a collar that has a bearing effect, allowing for smooth movement.
- By using a special set pin, it is possible to fix the set pin without any shaking.
It also eliminates moss falling off in the front, back, left and right directions.
・The number of parts has been reduced, making replacement and adjustment easy. Each part is sold separately, so you can rest assured.
- Costs can be reduced by using genuine safety parts.
- A new dedicated piston end has been manufactured.
- Equipped with a trigger stroke adjustment screw, you can adjust the stroke to your preference.

PDI set pins are firmly fixed with screws to prevent them from falling out!!

!!!!please note!!!!
This product is a dedicated part for the PDI cylinder set series.
Please be sure to use it in combination with the PDI cylinder set series. It cannot be used with genuine cylinder sets, cylinder sets from other manufacturers, or PDI cylinder sets (BORE UP series) due to the different piston end shapes and sizes.

★One-point advice★
When installing the trigger, make sure that the set pin is installed perpendicular to the cylinder.
If you tighten the screws from both sides without checking, the set pin will not be vertical but will be tilted, resulting in poor cocking.
While carefully checking that the set pins are not touching each other, tighten the set pin screws little by little from both sides.
If cocking becomes difficult after installing a Nutrigger, or if the set pin is worn down even after only a few uses, this is because the set pin is not installed vertically and is contacting the cylinder at an angle.

*This product cannot be used with the "VSR-10 BORE UP".

Specifications
■Compatible models:
#Tokyo Marui VSR-10
■Surface treatment: Black anodized, black dye
■Set contents: Nutrigger 2 main body, dedicated piston end

[About anodized aluminum products]
*During the anodizing process, unevenness or marks of a few millimeters may remain where the product is fixed.
*Since the screw part is inspected after the anodizing process, some of the anodizing on the screw part may peel off, resulting in silver areas, but if there is no problem with the functionality, we will treat it as a normal product.
*We have confirmed that the product can be used without any functional impact, so we do not accept returns or exchanges for cosmetic reasons.


※please note※
If you have customized your airsoft gun or replaced parts, be sure to measure the bullet speed using a bullet speed meter to ensure it is within the legal limit (possession of bullets over 0.98 J is prohibited). Also, be careful not to exceed the legal limit during the work.