This external carbon dioxide (CO2) power system has a lower environmental impact than standard refrigerant gas. Its pressure changes little with temperature, maintaining stable power even in low-temperature environments or when the temperature drops due to rapid fire. It's also the most compact external-source system available. Due to its characteristics, it's a popular system in the speed shooting world, and with the increase in tatami room shooters due to the stay-at-home lifestyle, it's now experiencing a quiet boom.
Connector plug for Sun Project Green Gas System/external power source that connects the gas gun and hose in an L-shaped direction.
Ver. II minimizes flow rate reduction and provides more stable power supply.
If you have a coupler, you can add it here.
Compatible with: Tokyo Marui and Maruzen gas guns, etc.
Compatible with M4.5 pitch 0.5 screw diameter.
Simply replace the injection valve of the gas gun magazine you are using with this connector, and then connect the connector to the corresponding coupler (sold separately) to use it.
*Not compatible with older versions of couplers and connectors (SP-13, SP-14, SP-10).
Installation example:
[Installing a plug in a gas gun]
●Remove the injection valve from the gas gun and screw it in by hand instead.
To change the orientation of the plug, use a flathead screwdriver to loosen the flathead screw.
Determine the direction and tighten lightly again until it is secure.
If gas leaks occur when fixing the unit, please use the included sealing tape.
If you screw it in too tightly, it may be damaged.
*When removing the injection valve, use a valve wrench.
Electroless nickel finish
Caution: Improper use may result in accidents or malfunctions.
■Do not leave within reach of small children.
■Depending on the gas gun, even if it is from the same manufacturer, the screw diameter of the injection valve may differ.
