This is an SBD (Schottky Barrier Diode) for electric guns.
Simply connect it to the + and - terminals of the motor to significantly reduce wear on the switch.
This will enable a longer lifespan.
Compared to FETs, the major features are that it is easy to install and there is no risk of runaway.
*Note*
Do not use in conjunction with electronic control units such as FCU or FET (with or without brake).
In the case of an FCU, this can cause problems with operation and, in the worst case, damage.
In the case of FETs, most products already have a component equivalent to an SBD built in. Peel off the clothing and fix it together with the brush line,
Solder it in a place where it won't get in the way.
Four round terminals, including a spare, that can be attached to the motor screws are included, allowing for a variety of installation methods.
The compatible power supply voltage is 13.2V (up to 4 LiFePO4 cells),
The effect is confirmed using an oscilloscope.
The instruction manual can be found
here .
![[GAW] SBD Standard Package for Electric Guns](http://rock-et.jp/cdn/shop/files/SBD_image1_1024x1024.webp?v=1737516631)
![[GAW] SBD Standard Package for Electric Guns](http://rock-et.jp/cdn/shop/files/SBD_image2_1024x1024.webp?v=1737516636)
![[GAW] SBD Standard Package for Electric Guns](http://rock-et.jp/cdn/shop/files/SBD_image1_medium.webp?v=1737516631)
![[GAW] SBD Standard Package for Electric Guns](http://rock-et.jp/cdn/shop/files/SBD_image2_medium.webp?v=1737516636)
