Based on Micro Mosfet2
This is a pre-wired FET that can be installed in Tokyo Marui electric handguns.
BEC connector, 0.5sq silicone cord, signal wire
It has already been installed.
The motor and switch are soldered to the wiring.
It's a simple FET switch with no programmability whatsoever.
Manufacturer recommended usage conditions
Battery voltage: 17V or less
Spring guide: M160 or less
Load in semi-automatic mode: 75A or less
Load in full auto mode: 25A for 30 seconds or less
・Turnigy nano-tech plus 7.4V 300mAh 70C~140C
・Turnigy nano-tech 7.4V 300mAh 45C~90C
・Turnigy nano-tech 7.4V 300mAh 35C~70C
Using a low-output battery will cause the FET to overheat,
A high-output battery such as those listed above, or something similar, is recommended.
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_1024x1024.webp?v=1753334537)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_2_1024x1024.png?v=1753334555)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_1_1024x1024.webp?v=1753334555)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_2_1024x1024.webp?v=1753334555)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_medium.webp?v=1753334537)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_2_medium.png?v=1753334555)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_1_medium.webp?v=1753334555)
![[Jefftron] AEP Mosfet](http://rock-et.jp/cdn/shop/files/JT-MOS-NG_2_medium.webp?v=1753334555)
