[da Vinci Custom] Chamber packing for electric guns "Batsura" 50 degrees

*Please note that this item is made to order and will take approximately 1-2 weeks to be shipped after your order is placed.

"A source of high-quality hops" desired by barrel makers
Introducing "Basara" chamber packing for electric guns

- Made of nitrile rubber
・Hardness 50 degrees

The HOP mechanism developed by Tokyo Marui to achieve long-distance trajectories has since spawned HOP models from various custom parts manufacturers, with the V-packing being one of its derivatives.
Basara Packing has considered what elements are necessary for V-packing, eliminated unnecessary ideas,
Focusing on "ease of setting" and "improved accuracy",
To maximize the potential of the V-packing, we have updated it with the latest technology. The bullet is held in a "V" shape at three points by the packing: two at the top and one at the bottom on the barrel wall.

Barrel combinations proposed by a barrel manufacturer
Da Vinci Custom has been providing high-quality inner barrels for a long time, and this allows us to offer the optimal combination with the barrel.
We have improved the difficulty of assembly due to the tight design and pursued a pure V-packing. By focusing solely on "improving ballistics," it has achieved high compatibility with Da Vinci Custom 's custom barrels, "Guren" and "Raizen."

[Guideline for installation]

When the HOP dial is fully turned down, the pressure of the "insect rubber" is weak, making it difficult for the protrusions to descend, resulting in a shallow HOP.
Although it varies from gun to gun, BBs may spill out of the muzzle in some cases. This can happen even with the original packing. If this happens, turn the HOP dial about 10% to increase the HOP.

When the HOP dial is set to the maximum, the pressure of the "insect rubber" increases, causing the protrusion to protrude and resulting in excessive HOP. This reduces the initial velocity by more than 10%. In some cases, the bullet may jam, so when turning the dial above 80%, please pay close attention to the trajectory and bullet feeding.

In a verification test at da Vinci Custom, the stable setting was HOP level 10% to 70%. We have confirmed that this is within the range.
I think there are optimal settings for HOP levels of 0-10% and 70-100%.
For customers who want to "start off by enjoying it casually," good results tend to be obtained by trying a HOP level of 10-70% .
On the other hand, it is believed that the potential of the custom parts used at other levels can be brought out. Adapt it to your purpose.