[Kuramae Koubou] APS-3 Original Front Sights

We have improved visibility by incorporating a light-gathering acrylic into the front sight produced by a 3D printer.
We also offer sizes not available in genuine front sights and a version without light-gathering acrylic, so please refer to the product description below.
*Price is per item.

【Front Sight Width】
You can choose from 3 types: 4.5mm / 4.8mm / 5mm.

【Front Sight Height】
There are two types: High and Low. High is approximately 1mm higher than the normal one.
Low is almost the same height as the genuine front sight.

【Light-Gathering Acrylic Installation Shape】

You can choose from two types: conventional and horizontal.

【Without Light-Gathering Acrylic】
We have prepared two versions without light-gathering acrylic, only for the 5.0mm width.





～How to choose each front sight～

【Front Sight Width】
If you feel that the width of the recess in the genuine rear sight is too wide and makes sight alignment difficult to see, select the 5mm width.

↑How the 5mm wide front sight looks
*The gap between the front sight and rear sight varies greatly depending on the distance from your eye to the sight (arm length).

【Front Sight Height】
If you want to lower the point of impact further, select the High one.
While 6 o'clock hold is recommended for competitive shooting, if you can't lower the point of impact enough even when adjusted to the maximum on some models, or if you can only use light BBs due to range restrictions and can't achieve the desired 6 o'clock hold, select the High one.

【Light-Gathering Acrylic Installation Shape】
The horizontal type has the advantage that the light-gathering acrylic is installed in the same direction as the shooter's line of sight, and the end face of the light-gathering acrylic is viewed from the front, making it appear perfectly round.
Also, since there is more exposure of the light-gathering acrylic, it appears brighter.
The light-gathering acrylic diameter is 1.5mm, and it is fixed with a grub screw.
1.5mm light-gathering acrylic rods can be purchased separately for repair in case of damage.

The conventional type has a shape equivalent to the one previously sold by Kuramae Kōbōsha using genuine front sights. The light-gathering acrylic used is also the same as the conventional one, with a diameter of 1.8mm, and is fixed with a grub screw.

*JASG certified parts.
*Since the horizontal type has a large exposed portion of the light-gathering acrylic, please be careful not to damage the acrylic when attaching or detaching the muzzle cover.
*There may be slight individual differences in the finish, and it may differ from the photo. Please be aware of this in advance.